How To Build An Above Ground Pool Base

Pack the sand or dirt down firmly so it provides a solid. Unless your yard is perfectly flat, it's important to level the area before you put down the plywood for the inflatable pool.

Installing an Above Ground Pool with a Sand Base and Foam

This is probably the top mistake we see people make.

How to build an above ground pool base. Above ground pools require a base material to be laid for the construction of the pool. I have an 18ft x 5ft framed pool with an overlap liner that i want to replace. I have bought an intex 20'x48 pool and am in.

Building up the low areas with dirt taken from the higher areas. Tape for foam board base. Mason sand or stone dust base material is used most often.

If you use an earth cove, use screened damp earth to form an even and consistent cove around the inside base of your pool's walls. Installing an above ground pool on sand in 5 steps the best solution is to dig down about ten centimetres and cover the surface with a ground cloth, which is used to protect the pool. The sand acts as a protective layer for your liner.

Avoid these common mistakes when building your above ground pool. There are two types that are most commonly used in above ground pool construction. The foam cove should then be installed on top of the sand base.

Instead, use sand or dirt to build up indentations in the yard until the area is level. I'll be replacing my 24' above ground pool liner and after reading all about the smooth and flat bottom that foam boards offer, i'm going to install foam. Newbie trying to use topsoil to build up to level.

For areas with severe weather or cold, a 6 inch base is recommended rather than a 2 inch base; If you are using foam cove you will need 3 yards or 4.5 tons. Any of the 4 x 8 sheets of foam make a nice base, it does not have to be the most expensive.

After clearing the ground of excess soil, rocks, roots and any other debris that could damage the base of the pool over time, you can fill the hole you have made with sand. The easiest way to check for levelness without special equipment is to look for them. Do a visual inspection to check for any spots that are.

But for this project, getting a frame pool set is your best option. Placing the plywood directly on an uneven yard is not ideal. A concrete pad is strong.

Finally, do not use excessive amounts of sand. Click here to post comments. Construction of your above ground pool build the bottom ring:

Foam cove is 3 3/4″ high. If you are pushing the dirt around to level out the site for the pool, eventually the dirt will settle and your pool will no longer be level. Build a sand cove against the pool wall by creating a 4″ angle of sand (on top of the 3″) sand base giving you a total sand cove height of 7″ inches where the base meets the metal pool wall.

Concrete slabs vary from 4 to 8 inches thick. For a 27′ round above ground pool you will need 4 yards (5.5 tons) of fine mason sand. I keep reading that you need to dig down but i am having 10 cubic yards delivered so i will have so much topsoil that i was.

Step 1, check for levelness to identify high spots. Drain my above ground pool completely. After the cove and the sand base are in place, rake and tamp the entire pool area.

Now you would need a deck to make it a beautiful feature in your property and the best way to keep your expenses low is to use pallets or reclaimed timber. The base actually stays smoother than the results you would obtain with sand or other types of pool pads. If there is less to erode, then any problems you have will be smaller.

Follow the instructions that come with your above ground pool package as each type, brand and size of pool have different instructions. The weight of the water compresses the foam so the indentations are very minimal. This will have sand coming up onto your cove as well in order to make the sand base completely level around the pool.

Building A 16'x16' Pool Deck Pool deck plans, Above